Rockwell Automation Guardmaster 440R-ENETR, User Manual, Page: 64 / 86

64 Rockwell Automation Publication 440R-UM009C-EN-P - July 2019
Chapter 7 Diagnostic Status Indicators
Table 19 - Diagnostic Status Indicator Descriptions
Indicator Status Description and Recommended Actions
Module status OFF No power is applied to device.
AOP: ConnectionFaulted = 0
Check the voltage at terminals A1/A2.
Solid green Device operating normally.
AOP: ConnectionFaulted = 0
No action necessary.
Flashing green Device needs commissioning due to missing, incomplete, or incorrect configuration.
Update module configuration (See
Upload Method on page 33 ).
Check for missing IP address.
Check if automation controller is in program mode.
Cycle power.
Flashing red/green Module self-test on power-up.
No action necessary.
Flashing red Recoverable fault.
Complete firmware update.
Verify address switches.
Check for monitored safety relay fault - PWR/Fault indicator may be red or Device Fault bit may be 1.
Power was cycled to one of the monitored safety relays.
Cycle power.
Solid red Unrecoverable fault; may require device replacement.
Cycle power.
Network status OFF Device is not online.
Device has not completed Dup_MAC_ID test.
Device not powered - check module status indicator.
Flashing green Device is online but has no CIP connections in the established state.
Solid green Device online and has CIP connections in the established state.
Flashing red One or more CIP connections in timed-out state.
Check for Guardmaster safety relay failure and controller operation.
Solid red Duplicate IP address detected.
Verify IP address setting and correct, as needed.
Link 1 or Link 2 Activity / Status OFF No link established. Check RJ45 connections at top or bottom of ENETR interface.
Solid green One of the following conditions exists:
• A 100 Mbps (full or half-duplex) link exists.
• The ring network is operating normally.
No action necessary.
Flashing green Transmit or receive activity present on indicated port @ 100 Mbps.
AOP: EthernetLinkxSts = 1 if ConnectionFaulted = 0
AOP: EthernetLinkxSts = 0 if ConnectionFaulted = 1.
No action necessary.
Solid yellow One of the following conditions exists:
• A 10 Mbps (full or half-duplex) link exists.
• The ring network is operating normally.
• AOP: EthernetLinkxSts = 1 if ConnectionFaulted = 0.
• AOP: EthernetLinkxSts = 0 if ConnectionFaulted = 1.
No action necessary.
Flashing yellow Transmit or receive activity present on indicated port @ 10 Mbps.
AOP: EthernetLinkxSts = 1 if ConnectionFaulted = 0.
AOP: EthernetLinkxSts = 0 if ConnectionFaulted = 1.
No action necessary.