50
Rockwell Automation Publication 6200-UM001C-EN-P - July 2018
Chapter 7
Clean the Thin Client or Computer
Clean the Integrated Display
Perform the following steps to clean a display (applies to VersaView 5000
ThinManager thin clients and industrial computers with an integrated display).
1. Disconnect power from the computer at the power source.
2. Clean the display with a mild soap and a clean sponge or a soft cloth.
3. Dry the display with a chamois or moist cellulose sponge to avoid water
spots.
Clean the Air Openings and Cooling Fins
Perform the following steps to clean all VersaView 5000 ThinManager thin
clients and industrial computers.
1. Disconnect power from the computer at the power source.
2. Disconnect all peripheral devices from the computer.
3. Vacuum dust and debris from the vent holes on the sides of the
integrated display computers, and from the cooling fins on the chassis of
all computers.
Remove stubborn dirt on the cooling fins with a mild detergent and soft
cloth.
Remove Paint and Grease from Bezel
Perform the following steps to remove paint and grease from the bezel of
computers properly mounted in IP65 enclosures.
1. Remove paint splashes and grease by rubbing lightly with isopropyl
alcohol.
2. Use a mild soap or detergent solution to remove residue.
3. Rinse with clean water.
ATTENTION:
Since the display is a touch screen, it is possible for
screen objects to activate during equipment wash-downs if the
computer is turned on.
ATTENTION:
Use of abrasive cleansers, solvents, and high-pressure
washes can damage the display window. Do not scrub or use
brushes.
ATTENTION:
Make sure the isopropyl alcohol does not come in contact
with the equipment labels. Alcohol can cause the label printing to smear.
