Rockwell Automation Allen-Bradley PowerFlex 700AFE, User Manual

Page: 41 / 186

Rockwell Automation Publication 20Y-UM001F-EN-P - April 2017 41
AFE in IP20 2500 MCC Style Enclosure – Installation/Wiring Chapter 1
Signal and Control Wire Types
Table 4 - Recommended Signal Wire for AFE in IP20 2500 MCC Style Enclosure
Table 5 - Recommended Control Wire for Digital I/O
Figure 22 - Door Control Box I/O Terminal Blocks and Jumpers
Signal Type Wire Types Description Minimum
Insulation Rating
Analog I/O
Belden 8760/9460
(or equivalent) 0.5 mm
2
(22 AWG), twisted pair,
100% shield with drain
(1)
(1) If the wires are short and contained within an enclosure that has no sensitive circuits, the use of shielded wire is not necessary,
but is always recommended.
300V, 75…90 °C
(167…194 °F)
Belden 8770
(or equivalent) 0.5 mm
2
(22 AWG), 3-conductor,
shielded for remote pot only
EMC compliance See CE Conformity on page 49 for details.
Type Wire Types Description Minimum
Insulation Rating
Unshielded Per US NEC or applicable national or local code —
300V, 60 °C
(140 °F)
Shielded Multi-conductor shielded cable such as Belden
8770(or equivalent) 0.5 mm
2
(22 AWG),
3-conductor, shielded
J1
J2
J3
J4
J5
Components that are mounted on inside of AFE
enclosure (see Figure 14 for location).
See Table 6 for door-control box item number descriptions and specifications.
Door Control Box Components
X3 Term. No. Default Description
57 and 60 — Remote momentary pulse of 0.4…1.0 sec. across these terminals starts
precharge in REM mode when terminals 58 and 61 are remotely closed.
58 and 61 — These terminals must be remotely closed to start precharge. Opening
these terminals opens the main contactor K1.
63 and 64 — Remotely closing these terminals resets an AFE fault.
65 and 66 — AFE run signal to the inverter enable input.
400 and 480 480
Control input voltage setting.
600 and 690 690
For jumper configurations,
see
Table 8 on page 46 .
(X3 Terminals)
2
3
4
1