8
Rockwell Automation Publication 2711T-QS002C-EN-P - March 2019
Second Generation MobileView Tethered Operator Terminal
Figure 1 - Printed Circuit Board (PCB) with Back Cover Removed
Install the Connection Cable to the Second Generation MobileView 2711T terminal
A 22-pin connection cable can be attached on the right or left side of the second generation
MobileView 2711T terminal for right- or left-hand operation.
Use the following tools to install the 22-pin connection cable:
• 19 mm open-end wrench or spanner
• Torx T10 screwdriver
• 8 mm hex key
IMPORTANT
Use the reset button when MobileView 2711T terminal functionality ‘locks up’ and you cannot
restart from the terminal desktop screen.
IMPORTANT
The second generation MobileView 2711T terminal is shipped with the cable connection port
open for right-hand operation. For more information, see
Connection
Cable
SD
™
Card
(1)
Circuit Board
Serial No. Label
Cable Channel
(1 of 2)
Reset
Button
Cable channel that is used is
only for example. Use channel
that is best suited for your
application.
Cable Channel
(2 of 2)
Cable Connector S3 Connects
to PCB Connector ETH
(Communication Interface)
Cable Connector S2 Connects
to PCB Connector S1
(Power and Safety Connection)
1)
The 2711T-T10I1N1-TC MobileView terminal does not have this feature.
Cable Connector S4 Connects
to PCB Connector S2
(Illuminated Push Button Connection)
