
Rockwell Automation Publication TLP-IN001A-EN-P - October 2019
15
Kinetix TLP Servo Motors with 046…235 mm Frame Size
Environmental Specifications
Always store motors in a clean and dry location within the environmental conditions.
Environmental Ratings
Motor Accessories
The following accessories are available for Kinetix TLP servo motors.
2090-Series Motor Cables
Factory manufactured feedback, power, and brake cables are available in standard cable lengths. They provide the sealing that is needed to achieve
environmental ratings and shield termination. If you choose to build your own cables, connector kits available for Kinetix TLP motors are described
in the Kinetix Motion Accessories Specifications Technical Data, publication
Contact your nearest Rockwell Automation sales office or refer to the Kinetix Motion Accessories Technical Data, publication
, for
information about available 2090-Series cables for Kinetix TLP motors.
Shaft Seal Kits
Shaft seal kits are available, as are replacement kits for field installation. A shaft seal provides a barrier that prevents moisture and particles from
entering the motor bearings. Shaft seals are made of nitrile and kits and require lubrication to reduce wear.
Shaft Seal Kit Selection
See Shaft Seal Kits for Kinetix TLP Installation Instructions, publication
, for instructions on how to install a shaft seal.
Environmental Specifications
Attribute
Value
Temperature, operating
0…40 °C (32…104 °F)
Temperature, storage
-10…+80 °C (-14 …+176 °F)
Relative humidity
20…95% noncondensing
Kinetix TLP Motors
IP Rating
(1)
(1)
IP rating descriptions are for reference only. Refer to the international standards for more complete rating descriptions.
Dust Protection
Liquid Protection
On-motor cable connectors.
IP30
Protection from objects with a
diameter of 2.5 mm (0.098 in.)
or more.
No protection from liquids.
Motor with shaft seal and Bulletin 2090 environmentally sealed cable
connectors.
IP65
(2)
(2)
IP40 without shaft seal installed.
Total protection from dust.
Protected against low-pressure jets of water from all directions.
IMPORTANT
Shaft seals are subject to wear and require periodic inspection and replacement. Replacement is recommended every 3 months, not to exceed 12 months,
depending on use.
Motor Cat. No.
Shaft Seal Kit Cat. No.
Motor Cat. No.
Shaft Seal Kit Cat. No.
TLP-A046
TLP-SSN-F046
TLP-A115
TLP-SSN-F115
TLP-A070
TLP-SSN-F070
TLP-A145
TLP-SSN-F145
TLP-A090
TLP-SSN-F090
TLP-A200
TLP-SSN-F200
TLP-A100
TLP-SSN-F100
TLP-A235
TLP-SSN-F235