Rockwell Automation Allen-Bradley DeviceNet 193-DNCT, User Manual

Page: 12 / 92

8 Rockwell Automation Publication 193-UM009B-EN-P - February 2013
Chapter 2 Installation and Wiring
193-DNCT-BZ1 Physical Connections
The optional Cat. No. 193-DNCT-BZ1 connects to the DeviceNet™ network via
an attached cable that has color coded bare leads. The cable’s bare leads are wired
to a DeviceNet™ connector according to the following table:
Powering the 193-DNCT
The DNCT must be powered from an external 24V DC source through the
communication cable. The 24V DC connections should be made to the V+ and
V- pins/wires in the above cable pinout/wire definitions.
ATTENTION: When mounting in a door or panel-mounted bezel kit,
only the Cat. No. 193-DNCT-BZ1 DeviceNet™ Bezel Kit should be used
with the Bulletin 193-DNCT DeviceNet™ Configuration Terminal.
Signal Function Color
V- Common Black
Can_L Signal Low Blue
Drain Shield Non-insulated
Can_H Signal High White
V+ Power Supply Red
ATTENTION: Before physically connecting the DNCT to a target device,
verify that the external power supply has adequate capacity to power all
devices on the network.