1769-L32E, 1769-L35E CompactLogix Controller
11
Publication
1769-IN020D-EN-P - October 2008
7. Attach an end cap terminator (E) to the last module in the system by
using the tongue-and-groove slots as before.
8. Lock the end cap bus terminator (F).
Mount the System
Minimum Spacing
Maintain spacing from enclosure walls, wireways, and adjacent equipment.
Allow 50 mm (2 in.) of space on all sides, as shown. This provides ventilation
and electrical isolation.
ATTENTION
During panel or DIN rail mounting of all devices, be sure that all debris (such
as metal chips or wire strands) is kept from falling into the controller. Debris
that falls into the controller could cause damage while the controller is
energized.
Bottom
Side
Side
Top
Com
pac
tL
og
ix
Co
ntro
lle
r
Po
wer
Suppl
y
Comp
ac
t I/
O
Mod
ule
End Ca
p
50 mm
(2 in.)
50 mm
(2 in.)
50 mm
(2 in.)
50 mm
(2 in.)
Com
pac
t I/O
Mo
dule
