24
Rockwell Automation Publication CC-QS027D-EN-P - August 2015
Chapter 1
900-TC Temperature Controller Setup
Set the Parameters Used in This Building Block Application
Change the following parameters for this application.
Upload and Save Your Settings
Follow these steps to upload and save the settings made in the two previous sections. Once the program has been uploaded
and saved, you can download it to other 900-TC temperature controllers.
1. Click the radio button to activate the lower panel in the main dialog box.
2. Click Upload.
Parameter
Setting
Parameter
Setting
[2] Set Point
80
[50] PID/OnOff
1 = PID
[3] Alarm Value 1
75
[56] Direct/reverse Operation
1 = Direct
[6] Alarm Value 2
85
[57] Alarm 1 Type
8 = absolute value, upper limit
[9] Alarm Value 3
0
(1)
(1) Set this value to zero because the value is not used on the 900-TC16 temperature controller.
[59] Alarm 2 Type
8 = absolute value, upper limit
[43] Input Type
7 = J type thermocouple
[61] Alarm 3 Type
0
(1)
[47] Temperature Unit
1 = Fahrenheit
[105] Auto/Manual Select Addition
1 = Manual
(2)
(2) Do not set this parameter to manual for On/Off control.
Radio Button