Rockwell Automation Publication IOLINK-UM001A-EN-P - August 2017
15
Chapter
2
Set up the 836P Sensor for IO-Link Mode
This chapter shows the physical hardware and software that is required to
configure the 836P pressure switch through IO-Link and provides a simple
guide to install the hardware.
Hardware
Required:
• 836P solid-state pressure display sensor
• CompactLogix™ or ControlLogix® PLC platform
• POINT I/O™ communications interface: 1734-AENTR
• POINT I/O IO-Link master module: 1734-4IOL
• POINT I/O terminal base: 1734-TB
• RJ45 network cable for EtherNet/IP™ connectivity:
1585J-M8TBJM-1M9*
Optional:
• 889D cordsets: 889D-F4AC-5
x
(IO-Link maximum acceptable cable
length is 20 m (65.6 ft))
Software
Required:
• Studio 5000® environments, version 20 and higher
• Sensor-specific IODD
• 1734-4IOL IO-Link Add-on Profile (AOP)
Summary of Contents for Allen-Bradley 836P Series
Page 45: ......
