Rockwell Automation Publication 48CR-UM001A-EN-P - November 2019
27
Configure for EtherNet/IP Network
Chapter 4
When the IP address assignment is made, the address displays in the IP
address column in the Request History section.
4.
To assign this configuration to the device, highlight the device in the
Relation List panel and click Disable BOOTP/DHCP. When power is
cycled to the device, it uses the configuration you assigned and does not
issue a DHCP request.
Save the Relation List
You can save the Relation List to use later. To save the Relation List, you must do
the following:
1.
Select Save As … from the File Menu.
TIP
To enable DHCP for a device that has had DHCP disabled, highlight the
device in the Relation List and click Enable DHCP. You must have an entry for
the device in the Relation List panel to re-enable DHCP.