Rockwell Automation 9VT201-007HTNNN, User Manual, Page: 33 / 224

Installation/Wiring 1-19
Publication 9VT-UM001D-EN-P
Table 1.E Frame 2 - 6 Jumper Removal
(1)
(1)
Important: Do Not remove jumpers if the distribution system is grounded.
Frames Jumper Component Jumper Location No.
2-4 PEA Common Mode Capacitors Jumpers are located above the Power Terminal
Block (see Figure 1.15 ).
➊
PEB MOV’s
➋
5 Wire Common Mode Capacitors Remove the I/O Cassette as described on
page 1-28 . The green/yellow jumper is located
on the back of chassis (see Figure 1.15 for loca-
tion). Disconnect, insulate and secure the wire
to guard against unintentional contact with
chassis or components.
➌
MOV’s Note location of the two green/yellow jumper
wires next to the Power Terminal Block (
Figure
1.15 ). Disconnect, insulate and secure the wires
to guard against unintentional contact with
chassis or components.
➍
Input Filter Capacitors
6 Wire Common Mode Capacitors Remove the wire guard from the Power Terminal
Block. Disconnect the three green/yellow wires
from the two “PE” terminals shown in
Figure
1.11 . Insulate/secure the wires to guard against
unintentional contact with chassis or compo-
nents.
MOV’s
Input Filter Capacitors