Rockwell Automation 9VT201-007HTNNN, User Manual, Page: 25 / 224

Installation/Wiring 1-11
Publication 9VT-UM001D-EN-P
Power Terminal Block (Frames B…E)
Table 1.B Power Terminal Block Specifications (Frames B…E)
Table 1.C Wire Routing Recommendations
Figure 1.6 Typical Frame B…E Power Terminal Block Location (B Frame Shown)
Cable Entry Plate Removal
If additional wiring access is needed, the Cable Entry Plate on Frames
B…E can be removed. Simply loosen the screws securing the plate to the
heat sink and slide the plate out.
No. Name Frame Description
Wire Size Range
(1)
Torque
Maximum Minimum Maximum Recommended
➊
Power Terminal
Block B & C Input power and
motor connections 3.5 mm
2
(12 AWG)
0.3 mm
2
(22 AWG)
0.66 N-m
(5.5 lb.-in.) 0.6 N-m
(5 lb.-in.)
D 8.4 mm
2
(8 AWG)
0.8 mm
2
(18 AWG)
1.7 N-m
(15 lb.-in.) 1.4 N-m
(12 lb.-in.)
E 25.0 mm
2
(3 AWG)
2.5 mm
2
(14 AWG)
2.71 N-m
(24 lb.-in.) 2.71 N-m
(24 lb.-in.)
➋
SHLD terminal B…E Terminating point
for wiring shields — — 1.6 N-m
(14 lb.-in.) 1.6 N-m
(14 lb.-in.)
(1)
Maximum/minimum sizes that the terminal block will accept - these are not recommendations.
No. Description
➌
Suggested entry for incoming line wiring.
➍
Suggested entry for motor wiring.