Rockwell Automation 9VT201-007HTNNN, User Manual, Page: 187 / 224

Using the LCD OIM B-11
Publication 9VT-UM001D-EN-P
Figure B.8 Adjusting Parameters
Figure B.9 How to Adjust Each Parameter Type
To restore all parameters to their factory-default values, select Reset
Defaults from the Memory Storage menu.
Note that the parameter values are retained through a line dip or power
shutdown.
Parameter
Type
How to Adjust
Numbered
List Use up/down arrow keys to advance through the list of options.
Bit Use to move the cursor to the bit location you want to
change. Use to change the value of the bit.
Numeric Use to increase or decrease the value.
- Or -
Use
to move the cursor from digit to digit, and use to
increase or decrease the value of the digit.
Parameter: #
Parameter Name
Lower limit< >Upper limit
Value Units
Dflt
nnn
Parameter: #
Parameter Name
Lower limit< >Upper limit
Value Units
Dflt
nnn
Save change
Don't save
change
ESC/
PROG
Step 1. At the parameter entry
screen, press to
highlight the parameter
value.
- OR -
Parameter: #
Parameter Name
Lower limit< >Upper limit
Value Units
Dflt
nnn
Step 2. Adjust the parameter
value (see table B.2),
and then press
to save the value.
ESC/
PROG
If you do not want to save the
value, press to return to the
initial parameter screen. You can
then repeat steps 1 and 2 to
change the value, or press
to back out of this menu.
ESC/
PROG
(The screen shown here was
accessed using the
Parameters>P Numbers path)
The F1 key is defined as a
toggle to enable you to view the
parameter's current value and
the factory-default value.