Rockwell Automation 9VT201-007HTNNN, User Manual, Page: 132 / 224

4-2 Troubleshooting
Publication 9VT-UM001D-EN-P
A fault is a condition that stops the drive. There are three fault types.
The drive indicates faults in the following ways:
•
Ready LED on the drive cover.
•
Parameters 209 [Drive Status 1] and 210 [Drive Status 2].
•
Fault queue entries.
•
Pop-up screen on the LCD OIM. The screen displays:
–
Fault number
– Fault name
– Time that has elapsed since fault occurred.
Figure 4.1 Sample Fault Screen on the LCD OIM
The fault screen is displayed until it is acknowledged by pressing any
F-key or cleared in the drive by other means.
Drive Faults
Type Fault Description
➀
Auto-Reset Run When this type of fault occurs, and [Auto Rstrt Tries] (see
page 3-37 ) is set to a value greater than “0,” a
user-configurable timer, [Auto Rstrt Delay] (see page 3-38 )
begins. When the timer reaches zero, the drive attempts to
automatically reset the fault. If the condition that caused the
fault is no longer present, the fault will be reset and the drive
will be restarted.
➁
Non-Resettable This type of fault normally requires drive or motor repair. The
cause of the fault must be corrected before the fault can be
cleared. The fault will be reset on power up after repair.
➂
User Configurable These faults can be enabled/disabled to annunciate or ignore
a fault condition.
Press any F Key to
Acknowledge the Fault
Fault Auto
ACKNOWLEDGE
- Fault - Fxxxxx
Fault Text String
Time Since Fault
xxxx:xx:xx