Rockwell Automation 9VT201-007HTNNN, User Manual, Page: 100 / 224

3-38 Programming and Parameters
Publication 9VT-UM001D-EN-P
D
YNAMIC C
O
NTR
O
L
Re
sta
rt
Mo
des
175 [Auto Rstrt Delay]
Sets the time between restart attempts
when [Auto Rstrt Tries] is set to a value
other than zero.
Default:
Min/Max:
Units:
30.0 Secs
0.5/30.0 Secs
0.1 Secs
174
178 [Sleep Wake Mode]
Enables/disables the Sleep/Wake
function. Important: When enabled, the
following conditions must be met:
•
A proper value must be programmed
for [Sleep Level] & [Wake Level].
•
A speed reference must be selected in
[Speed Ref A Sel].
•
At least one of the following must be
programmed (and input closed) in
[Digital Inx Sel]; “Enable,” “Stop=CF,”
“Run,” “Run Forward,” “Run Reverse.”
Default:
Options:
0
0
1
“Disabled”
“Disabled”
“Direct”
F
ile
Gr
oup
No
.
Parameter Name and Description
See page 3-2 for symbol descriptions
Values
Re
lated
ATTENTION: Enabling the Sleep-Wake function can cause
unexpected machine operation during the Wake mode. Equipment
damage and/or personal injury can result if this parameter is used in
an inappropriate application. Do Not use this function without
considering the information below. Failure to observe this precaution
could result in personal injury or damage to equipment.
!
Conditions Required to Start Drive
Important: P089 [Logic Source Sel] = 0 “Terminal Blk”
Input
After Power-Up After a Drive Fault After a Stop Command
Reset by Stop-CF,
OIM or TB Reset by Clear
Faults (TB)
OIM or TB
Stop Stop Closed
Wake Signal Stop Closed
Wake Signal
New Start or Run Cmd. Stop Closed
Wake Signal Stop Closed
Direct Mode
Analog Sig. > Wake Level
Enable Enable Closed
Wake Signal Enable Closed
Wake Signal
New Start or Run Cmd. Enable Closed
Wake Signal Enable Closed
Direct Mode
Analog Sig. > Wake Level
Run
Run For.
Run Rev. Run Closed
Wake Signal New Run Cmd.
Wake Signal Run Closed
Wake Signal New Run Cmd.
Wake Signal