Recommendation for step rate on the motor driver with direct drive 1:1 of the Z-axis
Recommendation for step rate on the motor driver with ratio 2:1 of the Z-axis
Keep in mind that conventional lathes on the Z axis rarely achieve a higher accuracy than 0.02-
0.05mm. This is due to the long lead screw, which cannot achieve higher accuracy due to ther
-
mal expansion and inaccuracies. It is therefore unnecessary to set the resolution to a few mi-
crometers.
MAXIMUM FEED SPEED
The maximum feed rate in mm/revolution is directly linked to the ratio of encoder pulses, mo
-
tor steps/revolution and the thread pitch of the lead screw. The maximum feed rate is decisive
for the maximum thread pitch you can produce. Please note, however, that threads with a pitch
of more than 8 mm are very rarely turned.
17
Screwpitch [mm]
Transmission
Steps/Rev
on motor
Resolution per step
[mm]
1
1:1
400
0,0025
2
1:1
400
0,005
3
1:1
400
0,0075
4
1:1
400
0,010
4
1:1
800
0,005
5
1:1
800
0,00625
6
1:1
800
0,0075
8
1:1
800
0,010
Screwpitch [mm]
Transmission
Steps/Rev
on motor
Resolution per step
[mm]
1
2:1
200
0,0025
2
2:1
200
0,005
3
2:1
200
0,0075
4
2:1
200
0,010
4
2:1
400
0,005
5
2:1
400
0,00625
6
2:1
400
0,0075
8
2:1
400
0,010
Summary of Contents for ELS 4 Basic
