GEN.0000000003185 REV A
9
low er l eg reMoval
bo
XX
er r2C2 TeChniCal Manual
clamp one of the upper tubes, just below the top cap,
1.
in a bike stand and place an oil pan beneath the fork
to catch any oil that will drain.
do not scratch the upper tube while clamping it
into the bike stand. Clean any debris from the stand
clamp surface prior to clamping the upper tube. a
clean rag wrapped around the upper tube may be
used to protect the tube surface.
Use a 2 mm hex key to remove the rebound adjuster
2.
knob retaining bolt. Remove the beginning stroke
rebound knob, washer, and ending stroke rebound
knob.
Use a 24 mm flat wrench to loosen and remove the
3.
rebound shaft bolt. Remove the crush washer and
retainer from the bolt, then re-install the bolt two to
three turns.
Place a 12 mm socket over the rebound adjuster
4.
shaft, against the rebound bolt. Use a plastic mallet
to firmly strike the socket to free the rebound shaft
from its press-fit to the lower leg.
2
3
4
Summary of Contents for BoXXer R2C2
Page 1: ...2011 Technical Manual ...