Roche URISYS 2400, Operator'S Manual, Page: 50 / 166

Roche Diagnostics
B-26 Operator’s Manual · Version 1.0
3 Software URISYS 2400
Installation
COMM. parameter
a
To define the communication parameters
1 Press <COMM. Parameter> on the [System Parameters] screen. The
[COMM. Parameter] screen is displayed.
2 Press <Baud Rate>, <Parity>, <Bits Per Char.>, and <Stop Bit> to select
the settings for communicating with the host computer.
3
Press <PgUp> to return to the [System Parameters] screen.
Date/Time The operator can change the format of the date and time, and set the correct
local dates, which are displayed on the touch screen and reported with the
measurement results and in the alarm messages.
a
To select format and local settings for date and time
1
Press <Date/Time> on the [System Parameters] screen. The [Date/Time]
screen is displayed.
2
Press <Order> to change the format of the date.
3 Press <Time> to change the format of the time from 12 hour to 24 hour.
4
Enter the correct local date and time.
5 Press <Enter> after each entry.
6
Press <PgUp> to return to the [System Parameters] screen.
Changing the settings is only possible when the analyzer is set to “Host Off-line”
(see “Start conditions before sampling” on page C-5).
These settings must match the corresponding settings of the host computer. Only
specialists or trained supervisors should change these settings.