Roche OMNI C, Instructions For Use Manual

Page: 69 / 152

4 Measurement
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
4-5
4.2 Measuring procedure
If QC measurements are not performed or only incomplete or if the QC measure-
ment result is ignored, it can lead to incorrect measurement results, which may lead
to incorrect clinical decisions. Danger of personal injuries (for detailed information
see chapter "Quality Control")!
In order to start a measurement, the Roche OMNI C must be "Ready" and in the "Analyzer"
1
operating mode.
Depending on the settings the entry of a password or a mandatory input (input value) may
be required (see Reference Manual, chapter 3 "
Operating modes " – " Setup ").
Fig. 1
You have the option of measuring samples from syringes (without needles), ampoules and
capillaries.
1. For more detailed information about the operating mode "Analyzer", please see the respective chapter of these
Instructions for Use and the Reference Manual!
"Password protection active" "Mandatory input" "Ready" – without another func-
tion like Password, etc.