Roche OMNI C, Instructions For Use Manual

Page: 16 / 152

1 Introduction
1-8
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
1.7.2 Screen
All information (results, error messages, warnings, etc.) is displayed on the screen. The
screen consists of a 5.7" colour LCD that is covered with a touch-sensitive film ("touch
screen").
Fig. 3
Please refer to the respective chapters in these Instructions for Use as well as the Reference
Manual for more detailed information about the operating modes.
Parameter – Display on the "Ready" screen
Depending on the settings and the status of the instrument, the parameter buttons may have
the following appearance:
* Pressing the parameter button produces a status report (see chapter 7, " Trouble shooting ",
section " Electrode status ").
Parameter activated and ready Parameter not ready
(not calibrated)*
Parameter temporarily deactiva-
ted (but calibrated) Parameter not ready
(due to QC lock)
Parameter activated with QC
warning Parameter not ready due to remote
lock
Parameter temporarily deactiva-
ted with QC warning Parameter permanently deactiva-
ted (under "Setup")
operating mode
selection button
status line
additional
functions
parameter status
and selection