Roche OMNI C, Instructions For Use Manual

Page: 127 / 152

7 Trouble shooting
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
7-7
7.2.12 3015 Waste container full
Cause
•
Waste container is full
Remedy
• Change or empty Waste container according to the instructions
Consequence actions
• Waste container fill level measurement
7.2.13 3016 Waste container switch
Cause
• The Waste container (W) has been removed
•
The Waste container micro switch is defective
Remedy
• Reinsert the Waste container
• Check Waste container micro switch ("More functions > System > Test > Control sen-
sors > Monitoring sensors").
•
•
In case of recurrence, call customer service ( change if necessary)!
Consequence actions
•
Waste container fill level measurement
7.2.14 3017 Pump cal. error
Cause
• The pump calibration (rotational speed adjustment of the pump) failed
Remedy
• Check under "More functions > Test > Valves & Aggregates > Peristaltic pump". if val-
ues inside the following limits are displayed:
Pump volume: 40 - 70µl
FMS volume: 920 - 1050µl
• If the displayed values are outside of the limits, perform a FMS volume determination
and correct the FMS volume value.
• In case of recurrence, call customer service!
Consequence actions
• Aspirate Mix1
•
Conductivity calibration