Roche OMNI C, Instructions For Use Manual

Page: 125 / 152

7 Trouble shooting
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
7-5
7.2.6 3006 Temperature error
Cause
•
The module temperature is outside of the specified range:
• Measuring chamber (left and right): 37.00 °C ± 0.2 °C
• Measuring chamber cover: 37.00 °C ± 0.2 °C
• tHb-/ S O
2
module: 37.00 °C ± 0.2 °C
•
A heating device is defective
• The measuring chamber cover cable is defective
• A temperature sensor is defective
Remedy
•
Reduce / raise the room temperature
• In case of recurrence, call customer service!
7.2.7 3009 Conductivity cal. error
Cause
• The conductivity calibration has failed
Remedy
•
Press the "OK" button (start a system calibration)
• In case of recurrence, call customer service!
Consequence actions
• System calibration
7.2.8 3010 AQC cover open
Cause
• The AutoQC cover is open
• The AutoQC cover sensor (Hall sensor) is defective
Remedy
• Close the AutoQC cover
• Check the AutoQC cover sensor ("More functions > System > Test > Control sensors >
Monitoring Sensors").
•
In case of recurrence, call customer service (change components if necessary)!