Roche OMNI C, Instructions For Use Manual

Page: 124 / 152

7 Trouble shooting
7-4
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
7.2.3 3003 Flap open
Cause
•
The flap was opened:
- during a measurement
- during a calibration
- during another system stop
- in menu "System" and menu "System" is being closed
• The flap detection is defective
Remedy
• Close flap
• Check function of the flap detection board ("More functions > System > Test > Control
sensors > Monitoring sensors"), change if necessary
•
In case of recurrence, call customer service!
Consequence actions
• Wash
7.2.4 3004 Analyzer error
Cause
• The measurement progress was incorrect
Remedy
• Press "OK" button
•
Switch the analyzer off/on
• In case of recurrence, call customer service (the electronics is defective, change compo-
nents if necessary)!
Consequence actions
•
Wash
7.2.5 3005 Memory error
Cause
• Fundamental software functions can not be performed (memory problems, file system
problems), the correct operation of the Roche OMNI C can not be guaranteed
Remedy
• Press the "Reboot" button
• In case of recurrence, call customer service (the electronics is defective, change compo-
nents if necessary)!