Roche CoaguCheck Pro II, Operator'S Manual

Page: 43 / 188

Meter Setup •
3
43
3 Meter Setup
Note on presentation of screen
elements in this manual
Buttons are screen prompts that cause something to
happen when touched. The names of all buttons are
either shown as
bold
text or as the icon used on the
button (e.g., for OK ).
Other screen elements (e.g., Menu titles) are written in
italics . These screen elements are not active.
You can open any displayed function by touching (or tap-
ping) the button for it with your finger (or a special pen
for this purpose). “Tap” means: Touch the button, then
remove your finger from the touchscreen. The next
screen appears once you remove your finger.
If the meter did not automatically enter the Setup mode
(e.g., after the battery pack was replaced), you can open
the Setup Menu from the Main Menu .
If you have not set the date and time (after powering on
for the first time or because the battery pack was
removed from the meter for more than 10 minutes), you
cannot perform a test. In that case powering on the
meter takes you immediately to the
Setup
mode, where
you must set the date and time (see page 53 and fol-
lowing).
After date and time have been set, the meter automati-
cally moves to the
Main Menu
, where you can start a
test or enter more settings.