Roche CoaguCheck Pro II, Operator'S Manual

Page: 106 / 188

106
If the Parameter Selection option is enabled in the meter
settings, you are now prompted to select the parameter to
be tested.
8 Touch the button to select the parameter you want
to use.
9 The test strip icon prompts you to insert a test strip.
Remove a test strip from its container and close the
container again with the stopper.
10 Hold the test strip so the lettering with the test
name is facing upward.
11 Slide the test strip into the test strip guide in the
direction indicated by the arrows. Slide the test strip
in as far as it will go.
A beep indicates that the meter has detected the test
strip (provided the beeper is enabled).
The testing procedure for both parameters is similar.
For illustration purposes testing with PT test strips is
shown as an example.
Test
09:15 am
05/29/2015
aPTT
PT
Test
09:15 am
05/29/2015
P-ID: PID01
Müller, David
Op: Schulz
Par: PT
Exposure to external influences (such as humidity) may
deteriorate the test strips and may lead to error mes-
sages. Therefore, always close the strip container
immediately after removing a test strip.