Innovative Robotics Solutions
2. Maintenance
2.1 Batteries
All the Models of the robot can be charged while connected to the robot, and even when the
robot is in ON mode. Hence, for charging the battery of the module you need only to connect
the correct charger to the module. Note that the 24V charger is used for charging the Rover’s
battery.
The battery of the Rover module is located at the lower part of the module. To replace the
battery, open the cover by unscrewing the four screws that hold the battery cover in place. Open
the screws all the way, and remove them away. Then remove the cover downward. The battery
is located in its specific bay. To replace the battery simply disconnect the connector and replace
the battery. Finally to close the cover repeats the previous steps in a reversed order.
Email:
