15
Notes:
•
After cleaning, always remove the mop cloth to prevent
dirty water from leaching back into the clean water tank.
•
A dirty mop will compromise the washing performance.
Clean it before use.
•
To ensure cleaning performance, replace the mop every 3
to 6 months.
Notes:
•
Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the dock.
•
Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage of
hazardous substances.
•
In the event of accidental contact with battery fluid, rinse
thoroughly with water and seek immediate medical care.
C3-2—
Rinse the wheel and the axle with
water to remove any hair and dirt. Air-dry,
reinstall, and press the wheel and axle
back in place.
Note:
If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Clean the mainwheels with a soft, dry cloth.
C4
Main Wheels
*Clean every month
C5-2—
Remove the washable filter and
empty the dustbin.
C5-1—
Open the upper cover of the robot
and take out the dustbin.
C5
Dustbin and Washable Filter
*Clean every week and filter should be replaced every 6-12
months.
C7
Mop Cloth
C7-1—
Remove the mop cloth from the
mopping module. Wash and air dry the
mop cloth.
C6-3—
Four cliff sensors.
* Clean after each use and replace every 3 to 6 months
Note:
To prevent blockage, only use clean water without any
cleaning liquid.
Note:
Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C5-3—
Fill the dustbin with clean water.
Gently shake the dustbin, and then pour
out the dirty water.
C5-4—
Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
C5-5—
Leave the dustbin and the washable
filter to dry and reinstall them.
C6-2—
Wall sensor.
C6
Robot Sensors
*Clean every month
C6-1—
Dock locator.
C8-1—Mop Attachment Slot
*Replace them every 1 to 3 months
C8
Filter Components
Note:
To ensure cleaning performance, replace the filter
components every 1 to 3 months, depending on the water
quality and how often you use the robot.
C9
Charging Contact Areas
Clean the charging contacts of the dock and
the robot with a soft, dry cloth.
1.
Move your finger along the notch to
remove each filter.
2.
Insert new filter components and make
sure they are properly installed.
Battery
Removing the Battery
The robot is equipped with a high-performance
lithium-ion rechargeable battery pack. To
maintain battery performance, keep the robot
*Clean every month
Use a soft, dry cloth to wipe all sensors,
including:
Environment
Protection Information
* The following information applies only when disposing of the
robot and should not be followed for day-to-day operations.
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution. Remove
the battery before disposing of this product
and hand it to a professional battery
recycling facility for centralized disposal.
1.
Operate the robot without connecting to
the dock until it runs out of battery.
2.
Turn off the robot.
3.
Unscrew the battery cover.
4.
Remove the battery cover.
5.
Press the latch to pull out the battery
connector and remove the battery.
charged during normal use.