13
Instructions for Use
Press and hold the button to turn on the
robot. The power indicator will turn on and
the robot will enter standby mode. Press
and hold the button to turn off the robot
and complete the cleaning cycle.
On/Off
Note:
The robot cannot be turned off when it is being charged.
Press the button to start cleaning. The
robot will plan its cleaning route according
to its scan of the room. It splits a room
into zones, first draws out zone edges, and
then fills the zone in a zigzag pattern. In
so doing, the robot cleans all zones one by
one, efficiently cleaning the house.
Starting Cleaning
Note:
Placing a paused robot on the dock manually will end
the current cleanup.
Note:
After resetting is complete, WiFi and other settings will
be restored to factory defaults.
Note:
After spot cleaning, the robot will automatically return
to the starting point and enter Standby mode.
Press any button to the stop the robot
during operation. Press the button to
resume cleanup. Press the button to
send the robot back to the dock and end
the current cleanup.
Pause
Notes:
•
Cleanup cannot start if the battery level is too low. Allow the
robot to charge before starting cleanup.
•
If cleanup is completed in less than 10 minutes, the area will
be cleaned twice.
•
If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging, the
robot will resume where it left off.
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
will flash every few seconds. Press any
button to wake it up.
Sleep
Notes:
•
The robot will not go to sleep when it is charging.
•
The robot will automatically shut down if left in sleep mode
for more than 12 hours.
Charging
Automatically: After cleaning, the robot will
automatically return to the dock to charge.
Manually: In pause mode, press the button
to send the robot back to the dock.
The power indicator light pulses during charging.
Note:
If the robot fails to find the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
Error
If an error occurs while the robot is cleaning,
the power indicator will flash red and a voice
alert will sound. See “Errors” for solutions.
Spot Cleaning
Press and hold the button to start spot
cleaning. Cleaning range: The robot cleans
a 1.5 m (4.9 ft) x 1.5 m (4.9 ft) square area
centered on itself.
Resetting
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system. Press the Reset button,
and the robot will reset automatically.
Restoring Factory Settings
Notes:
•
The robot will go to sleep automatically if left in an Error
state for over 10 minutes.
•
Placing the robot on the dock in an Error state will stop the
current cleanup.
If the robot does not function properly after
a system reset, switch it on. Press and hold
the button and at the same time press
Zone 1 – Cleaned
Zone 4 – Next Zone
Zone 2 – Cleaned
Zone 3 – In Progress