Robopac ROBOT S7, Use And Maintenance Manual

Page: 57 / 92

ENG INFORMATION ABOUT THE USE
57
6.3.2. PROGRAMMING WINDOW
The window is displayed each time that an editable or programmable area is pressed.
A) Area: it displays the icon corresponding to the concerned parameter to be programmed.
The figure shows a typical example of window and the table includes the description of the icons.
B) Button: it is used to close the programming window.
C) Bar: it is used to (quickly) increase or decrease the value displayed in the area (E).
D) Buttons: they are used to increase or decrease (one unit at a time) the value displayed in the area (E).
E) Area: it displays the programmed parameter value.
Icon Description of the function
1 Setting the type of wrapping cycle
2 Machine forward speed
3 Carriage upstroke / downstroke speed
4 Height from the ground at wrapping cycle start
5 Reinforcement wrappings
6 Altimeter/photocell setting
7 Cut
8 Film height adjuster – roping device.
9 Film stretch
10 Ergonomic upstroke
11 Pre-stretch value