Robopac Compacta S4, Use And Maintenance Manual

Page: 99 / 115

99
INFORMATION ABOUT THE USE ENG
6.10. CYCLE START
1. Make sure that the film is blocked in the clamp.
2. Make sure that the machine is set up.
3. Place the product to be wrapped on the infeed conveyor.
4. Select the recipe from the control panel (see 6.3. “Description of control panel” - “Use of the panel”).
5. Press the “Start” button on the control panel to enable the automatism and press the foot pedal control to start
the work cycle.
Important
When you release the pedal during wrapping, before the outfeed presser lowers down, the cycle stops.
6. Bring the product to the initial position and carry out the restart operations (see paragraph 6.11. “Stop and restart
types”).
7. If the pedal is released after the outfeed presser has lowered down, the cycle will be completed.
The machine will carry out the wrapping automatically.
8. After the product has been transported onto the outfeed conveyor, pick it up.
6.11. STOP AND RESTART TYPES
During production, there can be voluntary or unforeseen conditions that will cause the machine to stop.
The possibilities are as follows:
- Temporary stop (voluntary);
- Stop due to blackout;
- Production end stop;
- Emergency stop.
Temporary stop (voluntary)
It may occur for a short work break, a few minutes.
Simply do NOT activate the START pedal.
Danger - warning
The machine is still in operation, just press the START pedal to restart it.
To restart operation:
1. Press the START pedal.
Stop due to blackout
In case of sudden blackout, the machine stops immediately.
The electric motors stop and the pneumatically operated components remain still in their position.
When power is back on, the machine does not continue its operating cycle but remains in the same position.