GoBoard B2 User Manual
www.roboconn.org
Contains confidential and proprietary information which may not be copied, disclosed or
used by others except as expressly authorized in writing by ROBOCONN.
13
4.7
Charging Port
Charging port is used to charge the skateboard battery by plugging in charger pin. Ideally the skateboard should be
switched off while charging. It takes around 3 hours to charge the full battery from 0 percent to 100 percent.
5.
Rem
o
te
The remote is used to control the skateboard in remote control mode. The function of individual part of remote is
described below.
Figure 6
- Remote Labeled Diagram
5.1
Throttle Knob
Pushing the throttle knob in the forward direction accelerates the skateboard and pushing in the backward direction
brakes the skateboard.
5.1.1
Skateboard Zero Speed Locking
If the skateboard speed is almost zero and throttle knob is pushed in the backward direction, the motors tend to lock the
position of the skateboard. The timeout for locking process in 10 seconds while the throttle knob is kept pushed and
motor is supplying braking power continuously. After the timeout, the motor is released.
5.2
Pairing Switch
Long pressing the pairing switch for 3 seconds while the skateboard is not connected to remote, the radio chip enters in
the paring mode. The connection led in this case blinks 1 time a second. This switch should not be used in normal case.
5.3
Shift Switch
The shift switch is used in multiple functions.
