Robland KM 775, Instruction Manual

Page: 11 / 70

Instructions manual KM 775 - 785
4
To trim edges made of the following materials:

Laminated plastics

ABS

PVC

Melamine products

Wood band in roll form

Strip up to 3 mm thick
* For max edge thickness. 3 mm, thickness max. board 40 mm.
The command post of machine is easily accessible for workers, and is located
outside danger zone for them. From that zone and to be in position to operate the controls,
worker is the increased visibility of the machine, being away and protected from danger
zone. The staff required for the work of the machine will be as maximum of two operators.
One located at the entrance to introduce boards and other to collect boards mechanized.
The space required for these, is found in paragraph 2.4. The connection of the machine
should be carried out only by authorized personnel.
Before any handling in the machine and safety and proper functioning of the
machine, must be read with care this manual.
2.3 Machine movement and sitting:
The machine must be lifted and transported taking into consideration that the
support points must be as close as possible to the transporting bars. Take all possible
precautions in machine lifting, handling and moving operations to avoid the risks of
unforeseen movements which could endanger persons or property.
The machine must be sited on a flat surface able to withstand the weight of the
machine. Site it in an optimum position with regard to operational requirements, where
electrical connection is easy and with enough light to ensure that all parts of the
machine are visible. If the machine is unstable once in position, the support bolts should
be adjusted until the machine is stable and level.
Machine transporting
points