4
Cleaning
Safety Precaution
Before cleaning your rangehood or performing any maintenance, please ensure that the range hood is turned off at the
power point.
Do not use abrasive cleaners to clean the range hood. The use of warm soapy water and a cloth are recommended.
Ensure that the range hood is cleaned regularly, as a build‐up of grease and fat may occur otherwise.
The filters on the range hood must be cleaned regularly to maintain efficiency, and prevent grease build up. The filter
mesh is made of metal. It is recommended that this is undertaken every 4 – 6 weeks, depending on frequency of use.
The filters can be cleaned with warm soapy water or a cloth.
Cleaning of the range hood must be performed as described above; otherwise there is a possibility of a fire hazard due
to grease and fat build up.
Replacing the Lamps
WARNING
: Before changing the lights, make sure that the appliance is unplugged from the
power source and that the lamps are cool.
1.
Open the filter and twist the face of the lamp anti‐clockwise to disengage the
lamp.
2.
Replace the GU10 3W LED lamp with an identical lamp:
a.
Max Wattage: 2 x 3W
b.
Voltage Range: 220 – 240V AC
3.
Replace the filter to the original position.
Troubleshooting
Fault
Possible Cause
Solution
Light on, but
motor does
not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact Service Department.
Motor failed
Contact Service Department.
Light does not
work, motor
does not work
House fuses blown
Reset/Replace fuses.
Power cord loose or disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One way valve and the air ventilation
entrance are not tightly sealed
Take down the one way valve and seal
with sealant.
Leakage from the connection of U‐shaped
section and cover
Take U‐shaped section down and seal.
Lights not
working
Broken/Faulty globes
Contact Service Department.
Insufficient
suction
The distance between the range hood and
the gas top is too far
Refit the range hood to the correct
distance.
The Range
hood inclines
The fixing screw not tight enough
Tighten the hanging screw and make it
horizontal.
