9
Cleaning and Maintenance
Filter clean
•
Clean the lint filter after each use.
•
Remove by pulling straight up. Cleaning filter
•
Use wiping cloth or your fingers. Install filter
If the filter is cleaned by damp cloth
or water, please install after the sun dry.
Cleaning cabinet and inner tube
•
Use soft damp cloth wipe when cleaning cabinet
and inner tube.
•
Not to rinse by water direct.
•
Not to use neutral scour wipe.
•
Not to use gasoline and alcohol wipe.
•
Make sure open the front door for aeration after
cleaning the inner tube.
Safety reset
1.
These dryers have a safety cut out switch which is activated by temperature.
2.
The safety reset button is on the backboard. If your dryer not heating this button must be
reset before the dryer can heat again. You may need to wait 10 minutes for cooling down.
3.
The most common reason for the dryer if overheat is a blocked filter.
4.
Clean the line filter after each load to prevent overheating of the dryer.
The cut out switch may operate for the following reasons:
1.
Lint filter is blocked.
2.
Exhaust outlets blocked at the front of the dryer.
3.
Poor ventilation in the laundry or room-open a window or door
4.
Lightweight garment eg. handkerchief, sucked over the filter.
Safety Reset Button
Use your finger or a pencil to press the button in until you feel it click.
