2
Electrical Connection
Electrical Safety
Danger of electric shock
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
•
Note:
The appliance must be placed in such a way that the power supply is accessible at all times.
•
Before connecting the appliance to the power supply, check that the power supply voltage and current rating
corresponds with the power supply details shown on the appliance rating label.
•
Never use a damaged appliance. Disconnect the appliance from the power source and contact your supplier
if it is damaged.
•
Danger of electric shock. Do not attempt to repair the appliance yourself. In case of malfunction, repairs are
to be conducted by qualified personnel only.
•
To avoid damaging the cord, do not squeeze, bend or chafe it on sharp edges. Keep the cord away from hot
surfaces and open flames.
•
Lay out the cord in such a way that no unintentional pulling or tripping over it is possible.
•
Do not open the appliance casing under any circumstances. Do not insert any objects into the casing.
•
Never use accessories which are not recommended by the manufacturer. They could pose a safety risk to
the user and might damage the appliance. Only use original parts and accessories.
•
Do not place objects with open flames, e.g. candles, on top, beside or inside the appliance.
•
WARNING
: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of
electric shock.
•
Fixed wiring for the appliance shall have an all-pole disconnection device.
•
Any electrical installation must be carried out by an authorised professional.
•
All fittings must be installed by a competent person in accordance with local regulations. If in doubt, consult
a qualified electrician.
•
Important:
Always switch off the electricity supply at the mains during installation and maintenance. It is
recommended that the fuse is withdrawn or circuit breaker switched off at the distribution board whilst work
is in progress.
•
This product must be earthed – if no earth feed wire is available, consult an electrician.
•
Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules. To
achieve this install appropriate switched fused connection unit.
•
Note
: A switched fused connection unit having a contact separation of at least 3mm in all poles should be
connected in fixed wiring.
•
Connect the incoming positive, neutral and earth cables to the terminals of the switched fused connection
unit. Ensure connections are tight.
•
The spur outlet must still be accessible even when your oven is located in its housing to enable the appliance
to be disconnected from the mains supply.
Connection to the mains supply
This appliance must be earthed
Our company shall not be held responsible for any damage caused by using the appliance without an earthed
socket. There is a risk of electric shock, short circuit or fire when not installed by a professional. The appliance may
be connected to the mains supply only by an authorized qualified person and the appliance is only guaranteed after
correct installation.
There is a risk of electric shock, short circuit or fire if the mains lead is damaged in any way. The mains lead must
not be clamped, bent or trapped or come into contact with hot parts of the appliance. If the mains lead is damaged,
it must be replaced by a qualified electrician.
The mains supply must correspond to be data specified on the rating plate of the appliance. The appliance mains
cable must correspond to the specifications and the power consumption.
