Please read this manual before use
Rechargeable Battery Pack
2
3
4
Battery pack illustration
Safety Precautions
• The battery pack is designed only for use with the Roberts R1 and R100
products. It should not be used as a battery power source for other devices.
• There are no user serviceable parts inside this product.
• Do not attempt to open or disassemble any part of the product.
• Do not puncture, crush, modify, or cause any unnecessary shock to the
battery. The battery may present a risk of fire, explosion or chemical burn if
mistreated.
• Do not dispose of the battery in a fire or incinerator.
• Do not leave, charge or expose the battery to a heat source such as in a car
under direct sunlight.
• Do not expose the battery to moisture.
• Do not use or charge the battery if it appears to be abnormally hot, swollen,
leaking or damaged in any way.
• Do not leave a charging battery unattended.
• The battery pack must only be used with the mains adaptor supplied with
your R1 or R100 radio, or a genuine replacement provided by Roberts
Radio. Do not use any alternative power source as a charger.
• Do not use the battery pack to power any product other than the Roberts R1
or R100.
• Check the room temperature range is between 0-40°C (32-104°F) before
charging the product/battery.
• Do not allow the product to be exposed to water, steam or sand.
• The product shall not be exposed to dripping or splashing and no objects
filled with liquids, such as vases, shall be placed on the product.
• Operate the product such that there is a minimum distance (10cm
recommended) to adjacent objects in order to ensure good ventilation. The
ventilation of the product should not be restricted by covering it with items
such as newspapers, tablecloths, curtains etc.
• No naked flame sources such as lighted candles should be placed on the
product.
• Avoid using or storing the product at extremes of temperature. Avoid leaving
the unit in cars, on window sills, in direct sunlight etc.
• Be sure to read additional safety instructions in the user guide for the
R1 or R100.
Battery pack installation
• Tools required – Philips-style cross-head screw driver, number 1.
1. Ensure that the
Switch
on the battery pack is in the OFF position.
2. Unplug your R1 or R100 at the mains and disconnect it from the mains
adaptor.
3. Remove any audio cables, Ethernet cable or USB memory device.
4. If using the R100, carefully shorten the telescopic aerial and push it back
into the cabinet.
5.
Note:
The battery pack connecter is located underneath the R1 or R100.
Remove the small cross head screw illustrated below and then remove
the connector cover.
Red indicator - Indicates the battery pack is charging
Green indicator - Indicates the battery pack is fully charged
Orange indicator - Indicates that the battery pack has less than
20% to 30% charge remaining.
Battery pack indicators
Accessory for the R1 and R100
The battery pack allows you to use your product away from the mains typically
for between 8 and 12 hours. The battery life available between charges will vary
according to the product volume and operating mode. The battery pack may be
recharged from empty in approximately 6 to 7 hours.
Battery pack performance
6. Take the small cross head screw and the connector cover and keep in a
safe place for future use.
Please continue overleaf.
ROBERTS
Battery pack lead
Battery charging indicator
Battery full indicator
Low battery indicator
DC input socket
Battery power switch
Thumb screws x 2
Connector cover on
your R1 / R100
Small cross
head screw
Battery pack connector