EN
EN - 34 -
Mode
Description
Restart
Software reset – all user parameters are kept
Factory defaults
Set all user parameters to factory default value
While holding down the
reset
button with
a paper clip, connect the unit to power and
continue to hold the reset button until the 3
status light turn green.
The system is then ready for setup.
Reset
RDM
compatible
device
Set to factory defaults /
reset through web interface
(Home page)
Set to factory defaults /
reset through RDM protocol
Set to factory defaults /
reset through local control,
when equipped with this option
6.5 Factory defaults
6.5.1 Modes
6.5.2 Control
T
If IP address unknown (due to a previous modification), IP address can be read from RDM protocol or
a
hard reset
must be done:
