ROBEL 13.80, Original Operating Instructions, Page: 26 / 93

Page 22
13.80
RAIL CUTTER
Cutting particles and sparks are therefore intercepted by the protection and
diverted from the operator.
•
Bring the device into position in compliance with safety regulations.
Right hand on the grip
(throttle handle), left hand
on the motor arch.
Symbol image (petrol
motor) only!
5.7.1 Abrasive cutting procedure
▪
The motor must constantly run at maximum speed.
▪
Never start the cutting process jerkily, but oscillate constantly to and fro
vertical to the rail.
▪
An economical cut can be achieved with the appropriate contact pressure up
to the performance limit of the motor, i.e. before the speed drops.
▪
Only execute the cut with one and the same cutting disk! (A new disk would
jam due to the unused width!)
▪
Track the cutting process with the protective hood, to guarantee optimum
spark protection!
▪
Cut through the railhead with an oscillating movement from top to bottom.