Then close
Slic3r
window.
Next, you have to specify the settings to be used in
Repetier-Host
(under the [Slicer] tab):
Congratulations! The software is up and ready to run.
8. Preparation for Work
The following is required to start printing:
1. Plug in USB cable to the computer and then to the 3D printer.
2. Connect power supply unit to the 3D printer and then to 220V main.
3. Replace adhesive tape on the print bed (if needed).
4. Heat 3D printer up to operation temperature (220°С).
5. To fill (replace) the filament, see Section 9.2.
6. Start
Repetier-Host
.
7. Prepare a model for printing.
21
Summary of Contents for MINI
