7.3. Software Setup
3D printer has two categories of settings:
Repetier-Host
settings and
Slic3r
settings.
Repetier-Host
settings are to be typed manually in the Printer Settings window.
For that, click the [Printer Settings] button:
Copy the values from the picture below (the [Connection] tab):
WARNING: while choosing COM port, the 3D printer should be connected.
Select COM port from the “Port” list, then click [Refresh ports] and try again.
3D printer will match the COM port that disappears on disconnecting USB.
17
Summary of Contents for MINI
