- Open box, tilt onto open side, slide box up
- Undo 4 cover straps
- Set extrusion rails aside
- Undo 2 side straps
- Open tent, remove ladder, cover, boot bags, gear
hammocks, and hardware bag, leave window poles,
close tent
- Flip to side with 4 holes
- Cut off plastic cover
- Align extrusion rails
- Slide nuts into rails
- Locate holes on opposite side, push bolts through
tape, tighten
- Flip tent
- Cut off plastic cover, remove tape
- Align brackets
- Locate holes on opposite side, push bolts through
tape, don’t tighten
- Align ladder, feed bolts through, tighten
- Tighten brackets
- Install boot bags and gear hammock
- Secure ladder strap
- Install cover
- Lift onto vehicle
- Drop botls through slides and slide into rails
- Sandwich rack with plate and tighten
- Install extrusion end caps
- Undo 4 straps
- Flip back cover, slide out of frame
- Undo side straps
- Undo ladder strap
- Extend ladder, use to lever open
- Pull out ladder awning pole, flip out brackets,
insert, velcro
- Grab bag of poles, insert into frame, bend and
insert in awning
- Roll up window covers
- Lift ladder, zip on annex, zip on floor
- When closing, use bungees
- Remove cover
- Insert annex cord into frame
- Fold up ladder
- Zip annex on
- Layout and zip on floor
- Fold ladder back down
SETTING UP CAMP
Setting up the annex:
1) To start, you’ll need to remove the tent cover if you have
not already. Do so by sliding it to one side and out of the
channel in the frame.
2) You’ll also want to get the ladder out of the way by
collapsing it and securing it with the velcro tie-down on the
base of the tent.
3) Grab the fabric walls of the annex and locate the corded
edge. Insert this edge into the same channel you just
removed the cover from and feed it through.
4) Locate zipper on the ladder awning and bring it all the
way to the left (if facing the vehicle.) Insert the end of the
zipper on the annex walls and zip the walls to the ladder
awning.
5) Locate the zipper on the base of the annex walls and
bring it to the starting point. Unfold the PVC floor, locate
the starting point on the zipper, and orient it with the base
of the annex walls so the ends of the zippers meet up. Zip
the floor to the walls.
6) Now you can lower the ladder back down and your
annex is ready to use.
8
