Installation and
operating instructions
FuseMaster 76511
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 800-669-9690 Fax: 360-735-9300 www.roadmasterinc.com
All specifications are subject to change without notice.
Time Tested • Time Proven
855429-00 06/15
Purpose
The FuseMaster 76511 will eliminate the necessity of hav-
ing to remove a fuse for towing, then reinserting it for driving.
After the installation you will flip a switch to accomplish the
same purpose.
The FuseMaster 76511 is for vehicles which must have one
ATM mini or one ATM micro fuse (not included) removed. It
is specifically designed for installations where the distance
between the fuse to be removed and the closest switch
mounting location is approximately 12 or 13 inches.
(The FuseMaster 76510 is for the same type of installation,
but three inches shorter.)
For a vehicle-by-vehicle fit list, visit www.roadmasterinc.
com. Select the “Vehicle-Specific Info” menu tab.
Required tools
•
fuse puller (for difficult-to-access fuses)
•
power drill with ¾-inch bit or ¾-inch flat auger bit
CAUTION
Read all instructions before installing or
operating this device. Failure to understand
how to properly install or operate the Fuse-
Master could result in extensive property
damage.
Note: if the fuse to be removed is located in the engine
compartment, see “Engine compartment installation,” at the
end of these instructions.
1.
Refer to the towed vehicle owner's manual to determine
which fuse must be removed for towing.
Note: running changes may not be reflected in the owner’s
manual. ROADMASTER recommends calling the dealership to
confirm which fuses must be removed.
2.
Remove the access panel and then the fuse.
3.
Confirm that the two silver pins at the end of the Fuse-
Master harness are the same size as the pins on the fuse you
removed. The pins must match.
CAUTION
Do not insert the fuse into the FuseMaster harness until
instructed to do so, or the fuse may blow.
Note: if the fuse is an ATM micro fuse, you must purchase
an ATM mini fuse of the same amperage to replace it — a micro
fuse will not fit in the FuseMaster fuse holder.
4.
Insert the two silver pins at the end of the FuseMaster
harness into the socket for the fuse you removed. Either pin
will work in either hole.
Gently press the pins down until they are fully seated.
Note: for vehicles with ATM micro fuses (for example, some
Honda models), press the silver pins to the outside edges of the
fuse socket — the sockets for these fuses have the connectors
at the sides.
You may find it easier to use the included fuse socket
continued on next page
Installation instructions
Notice
ROADMASTER, Inc. assumes no responsibility for
damage and accepts no liability in any way for the proper
or improper use or installation of this product, including
any warranty claims that may be considered voided by
the towed vehicle manufacturer or for any consequential
damage that may arise from its use.
Safety Definitions
These instructions contain information that is very im-
portant to know and understand. This information is pro-
vided for
safety
and to
prevent equipment problems
.
To help recognize this information, observe the following:
WARNING indicates a potentially hazardous situ-
ation which, if not avoided, could result in property
damage, serious personal injury or even death.
CAUTION
CAUTION indicates a potentially hazardous situ-
ation which, if not avoided, may result in property
damage.
NOTE
Refers to important information and is placed in italic
type. It is recommended that you take special notice of
these items.
