ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
#85-3905-02 10-12
1-800-669-9690
STOP LIGHT SWITCH BRACKET
INSTALLATION INSTRUCTIONS #751428
Failure to follow these instructions can result in
property damage, personal injury or even death.
WARNING
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 360-896-0407 fax 360-735-9300 www.roadmasterinc.com
1. Start by attaching the stop light switch to the bracket
— follow the separate instructions included with this
kit.
2. Locate the existing stud under the steering column
(Fig.A).
3. Place the stop light switch bracket over the exist-
ing stud and bolt into place using the supplied 8mm
x 1.25 nut, 8mm flat washer and 8mm lock washer
(Fig.B).
4. Install and wire the stop light switch according to the
instructions provided with it. Be certain to adjust as
necessary to allow for proper activation of the plunger
on the switch.
When the installation is complete, verify that the
brake pedal retracts fully.
Unless they are installed correctly, the bracket and/
or other kit components may restrict or impede the
movement of the brake pedal — the brake pedal will
not retract fully.
If the brake pedal does not retract fully, the brakes
will be applied continuously, which may cause severe
tire and/or brake system damage, as well as other con-
sequential, non-warranty damage.
Failure to follow these instructions may cause prop-
erty damage, personal injury or even death.
WARNING
Fig.A
Fig.B
Stop Light Switch
Existing Stud
q
q
Parts List
(1) 8mm x 1.25 nut
(1) 8mm flat washer
(1) 8mm lock washer