11
Yellow on Green;
Amber on White;
White on Amber;
Amber on Black;
Black on Amber.
Adding and Removing Color Modes
The unit has six default color modes. You can also activate and choose from a variety
of 27 other color modes. Once a color mode is available, you can easily switch to it by
pressing the blue COLOR MODE button, or the black UP ARROW and DOWN
ARROW buttons. (The UP/DOWN buttons only work if shading, masking, and reading
lines are off.)
Note:
Use the tip of a pen or similar item when performing this procedure. The enable
[tick] and disable [X] icons will display on the screen indicating if a color mode is
selected or cleared. Review this procedure before adding or removing color modes.
To add or remove color modes, do the following:
1. Open the battery cover on the back of the remote control.
2. Use a pen tip or similar item to press the MENU button. When holding the remote
control vertically, it is located above and to the left of the batteries.
The Enable check mark [tick] displays on the screen indicating that the current color
mode is active.
3. To disable the current color mode, press the light blue FLIP button. An X displays
and indicates that the color mode is disabled.
Note:
True Full Color mode is always available and cannot be disabled.
4. To scroll to the next color mode, press the blue COLOR MODE button.
A check mark [tick] indicates that the color mode is enabled
An X indicates that the color mode is disabled
5. To enable or disable another color mode, press the light blue FLIP button.
6. Repeat steps 4 and 5 to continue adding or removing color modes.
7. When you are finished, use a pen tip to press the MENU button to save your
changes, and then replace the battery cover.
Resetting Default Color Modes
If you have added or removed color modes, you can always restore the unit to its six
default color modes.
