6
The maximum reading shall be recorded in case of different results since
any thermometer used continuously is deemed to see a slight difference of
about +/- 0.3C or +/- 0.5F.
Remove the forehead probe to expose the ear probe. Carefully insert the
probe into the ear as deep as possible without discomfort and press the
measurement
button on the right edge once to start the measurement and
you will hear one beep. Upon completion you will hear a short melody, and
then the result will be announced via the speaker and it will be shown on
the display.
Do not use the product if you feel any pain in the ear.
To measure the temperature on the forehead
Ensure that the forehead probe has been put onto the unit, over the ear
probe. Gently position the probe onto the centre of the forehead, midway
between the eyebrow and hairline. The forehead adaptor needs to be in
contact with your skin.
Press the oval shaped
measurement
button on the back of the device once
to start the measurement and you will hear one beep. When the
measurement is completed you will hear two beeps and then the result will
be announced via the speaker and it will be shown on the display.
The result will be stored into the memory automatically. If there are already
30 results in the memory, the oldest set of data will be removed. This will
continue when every new result enters the memory. Also, the recorded data
will be removed automatically when it has exceeded 30 days in the
memory.
If a reading is considered irregular, try taking the temperature again at the
same point up to a maximum of three times. If the reading is still irregular,
wait 10 minutes and then try again.
When the measured temperature is between 37.6C (99.6F) and 42.9C
(109.3F), a red light will come on under the measure key to indicate there is
a fever.
