4
Display
The display shows the time (hour and minute) and the room temperature
which refreshes every five seconds. At the bottom of the display you will
find the year, month and date. You can press the
TALK
button situated at
the back of the device to hear the time and room temperature.
Change between Celsius/Fahrenheit
With the thermometer in waiting mode, measuring mode or memory mode;
press and hold
MEM
and
measurement
button used to take a forehead
temperature on the back to switch between degrees Celsius and degrees
Fahrenheit.
Setting the clock
Please note:
sighted assistance may be required for this setting.
Ensure that the thermometer is switched on by pressing any button. Press
and hold the
MEM
button until you hear one beep to enter the setup mode.
The hour digits will then start to flash. Press the
MEM
button to change the
hours and press the
TALK
button to confirm. The unit will beep and then
the minute digits will flash. Repeat the above process and then the setup
mode moves through to year, month, date, sleep mode on/off. Remember
to press the
MEM
button to change the time or date and toggle between
sleep mode on/off, and then press
TALK
to confirm. The unit will beep each
time to confirm that it has set and moved onto the next setup.
Setting the Sleep mode
The last setup is sleep mode. Press
MEM
button to alternate between on
and off and then press
TALK
button to confirm the setting. When activated,
the system enters into sleep mode one minute after the last button has
been pressed.
Please note:
if the TALK button is not pressed, the unit will automatically
return to show the information on the display after 30 seconds.
