30
31
EN
EN
7.Replacing the Batteries
WARNING:
To avoid electric shock, disconnect the test leads from any source of voltage
before removing the battery cover.
WARNING:
To avoid electric shock, do not operate the meter until the battery cover is in
place and fastened securely.
Refer to Figure and replace the batteries as follows:
1. Turn the Meter off and remove the test leads from the terminals.
2. Remove the battery door assembly by using a standard blade screwdriver to turn
the battery door screw one-half turn counterclockwise.
3. Replace the batteries with 7.4 volt charge batteries Observe proper polarity.
4. Reinstall the battery door assembly and secure it by turning the screw one-half
turn clockwise.
8.Replacing the Fuses
WARNING:
To avoid electric shock, disconnect the test leads from any source of voltage
before removing the meter cover.
WARNING:
To avoid electric shock, do not operate your meter until the fuse cover is in place
and fastened securely.
Referring to Figure, examine or replace the Meter’s fuses as follows:
1. Turn the Meter off and remove the test leads from the terminals.
2. Remove the battery door assembly by using a standard blade screwdriver to turn
the battery door screw one-half turn counterclockwise.
3. Remove the fuse by gently prying one end loose, then sliding the fuse out of its bracket.
4. Install only specified replacement fuses.
5. Reinstall the battery door assembly and secure it by turning the screw one-half
turn clockwise.
6. Remove the six screws securing the rear cover.
7. Gently remove the old fuse and install the new fuse into the holder.
8. Replace and secure the rear cover, battery and battery cover.
