RMG TME400, Operating Manual

Page: 72 / 156

4 Operation
MANUAL TME400-VCF · EN08 · July, 01 st 2021
66
the adjusted value (2% here), the correction, is set to "0" for
this operating point or operating range, which means a
correction takes place.
B08 Leak flow volume limit The flow rate is disregarded below this limit - i.e. it is set to 0
B09 Maximum time > Qug + Indicates the maximum time until the flow rate (e.g. on start-up )
reaches the measuring range (Qmin) after reaching the lower meas-
uring limit (Qug). The flow rate measurement applies as defective
during this time, but no error message is generated.
Coor-
dinate
Name Modbus
register
Modbus
access
Protec-
tion
Data
type
Min. Max. Default Unit
B01 Standard flow rate
318 R A
float
- - *
m 3 /h
B02 Operating flow rate
320 R A
float
- - *
m 3 /h
B03 Frequency
322 R
A
float
- - *
Hz
B05 Min. flow rate
521 W E
float
* * 0.0
m 3 /h
B06 Max. flow rate
523 W E
float
* * 1000.0 m
3 /h
B10 Coefficient A-2
530 W E
float
* * 0
Am2
B11 Coefficient A-1
532 W
E
float
* * 0
Am1
B12 Coefficient A0
534 W E
float
* * 0
A0
B13 Coefficient A1
536 W E
float
* * 0
A1x10 -4
B14 Coefficient A2
538 W E
float
* * 0
A2x10 -8
B15 Max. dev. operating point 540
W
E
float
0.0 100.0 2.0
kkp
B08 Leak flow volume limit
527 W E
float
* * *
m 3 /h
B09 Maximum time > Qug +
529 W E
uint16
0 10000 10
s
4.3.3.3.
Pressure
Coordi-
nate
Name Description
C01 Pressure Currently available pressure
C02 Pressure mode
Pressure measurement transmitter (source of the pressure measure-
ment)
0 Specification (default, fixed value)
1 Wika TI-1