3. Press the "Stereo" button to separate the left and right channel. Each channel now has its own
volume control which can be accessed by toggling the following button on the phones screen:
Follow the same procedure to join the two channels as a Stereo channel.
10.2.2. Muting the Phones Output
To mute the phones output
1. While on the main screen, press the headphone button. The phones settings opens.
2. Press the mute button. It turns red to symbolize that the phones are muted.
10.2.3. Using Phones Out as a Balanced Line Output
The headphone output can operate as a mono balanced line level output. This may for example be useful
when an active talkback speaker with symmetrical input is connected to the 12Mic.
To toggle balanced output mode on the Phones output:
1. On the main screen, press the Phones button to access phones output settings.
2. Press the encoder to open additional settings
.
3. Press the "BAL" button to switch the channel to balanced out. The channel that was routed to the left
phones output will now be applied to both tip and ring of a TRS connector, the phase being inverted
on the ring.
10.3. MADI Outputs
The MADI outputs of the 12Mic are always active. If no routing is configured, an empty stream is sent
that can be used for clocking. This state is represented with a light-green Status Indicator.
RME 12Mic User’s Guide
51
| 10.3. MADI Outputs