1. Navigate to the corresponding output channel (1, 2).
2. Double click on "Increment routing". The routing source will be changed to "not routed".
3.
(optional)
Hold "increment routing" while turning the encoder to remove routings to the following
output channels.
To route consecutive channels:
1. Navigate to the first output channel (1, 2) and create a routing as described above.
2. Hold "increment routing" while turning the encoder clockwise to increment input channel and output
channel at the same time.
10.2. Phones Output
The front TRS connector can be used for phones or as a balanced mono output.
Any incoming signal can be routed to the phones output. Analog input signals can
be temporarily routed to the phones output while the original routing remains
saved. A button on the standby screen gives access to all features of the output.
The analog output level meters show the routed input signal relative to 0 dBFS (pre gain)
in grey color in the background, and additionally the calculated output level
post gain
in
green color in the foreground.
10.2.1. Adjusting the Headphone Volume
The volume of the unbalanced phone outputs can be adjusted separately or as a stereo pair.
To adjust the headphone volume on the device:
1. While on the main screen, rotate the encoder. The current volume will be shown below the encoder on
the screen.
To separate the left and right headphone channels:
1. Open the headphone configuration by clicking the phones icon on the main screen.
2. Open the additional settings
by pressing the encoder.
RME 12Mic User’s Guide
10.2. Phones Output |
50